Skip to content
The yard after removal, with two tall conifers still standing and open sky where the cedar was

Removing a double-stemmed cedar beside a garage in Lonsdale

We took down a large two-stemmed cedar growing tight against a garage in Lonsdale. The tree was limbed, dismantled from the top in sections and cut to a low stump.

Mike Baron, OwnerNovember 10, 2026 · 2 min read · Lonsdale, North Vancouver

A big cedar with two fused stems stood right against a backyard garage in Lonsdale. We climbed it, stripped the limbs, lowered the stems in sections on ropes, and brought the last pieces down into the yard. The stump was cut low to the ground and the two conifers beside it were left standing.

The cedar against the garage

This cedar grew right up against the back corner of a garage in Lonsdale, with two other tall conifers beside it. You can tell it's a cedar from the drooping, fern-like sprays and the stringy bark on the trunk. Low down, the trunk splits into two stems that run up side by side.

A large two-stemmed cedar beside a garage, with two tall conifers behind it

With the garage roof under one side, there was no room to drop the tree whole. So it came down the slow way, from the top.

Limbing and taking the stems down in pieces

Our climber went up first and took off the limbs, leaving the two stems standing bare. With the branches gone, nothing snags on the roof or the neighbouring trees on the way down.

Two bare cedar stems beside a garage at sunset, with cut logs on the ground

From there the stems came down in sections. The climber cut each piece while rigging lines held and controlled it, so the wood landed in the yard and not on the garage. You can see the rope running down from the stem and the sawdust falling past the roofline.

A climber cutting a cedar stem with a rigging line running to the ground

Once the stems were short enough to clear the garage, the last pieces were notched at the base and brought down into the open yard, with a rope tied high on the stem to guide the fall. The rounds and brush piled up in the yard beside the garage.

A notch cut at the base of a cedar stem next to a garage, with a guide rope above

What's left

The stump was cut low to the ground. Looking down on it, you can see the two stems joined into one wide, fluted base, with the seam where they grew together still showing in the wood.

A wide, fluted cedar stump cut low to the ground, seen from above

The work day was wet, with steady rain in a rainy week.

The view from the yard now shows open sky where the cedar was. The two conifers that stood beside it are still there, and the garage roof is clear of the cedar.

The yard after removal, with two tall conifers still standing and open sky where the cedar was

If you have tall trees left near a building after a neighbouring tree comes out, keep an eye on them through the first winter storms. Trees that grew up sheltered by others are suddenly more exposed to wind.